1. Plug your MineOne PRO into a power source using the provided USB cable.
2. After a few seconds, a message will appear on the display telling you to scan a QR code.
Scan the QR code
1. Open the camera app on your smartphone.
2. Scan the QR code shown on the miner’s screen.
3. The code contains the Wi-Fi network name and password for the miner’s temporary Wi-Fi network.
Connect to the miner’s Wi-Fi
1. After scanning, your phone may automatically prompt you to join the miner’s Wi-Fi network.
2. If it doesn’t: Go to your phone’s Wi-Fi settings.
3. Find and select the Wi-Fi network name shown on the miner’s screen.
54. Enter the password if asked.
Open the configuration page
1. Once your phone is connected to the miner’s Wi-Fi, a setup page may open automatically in your browser.
2. If it doesn’t open: Open your web browser manually.
3. In the address bar, type 192.168.4.1 and go to that page.
Configure Wi-Fi and Bitcoin address
1. On the setup page, tap “Configure Wi-Fi”.
2. Choose your home 2.4GHz Wi-Fi network from the list and enter its password.
3. Note: The miner only works on a 2.4GHz network, not 5GHz.
4. Enter your Bitcoin wallet address in the Bitcoin address field.
5. Delete any placeholder text so only your wallet address is there.
6. Leave the mining pool settings as they are unless you specifically want to change them.
Save your settings and start mining
1. Click “Save” to apply your settings.
2. The miner will restart and connect to your home Wi-Fi network. This usually takes about 10–15 seconds.
3. Once connected, the miner will show its new IP address on the screen.
4. To monitor the miner, type that IP address into your web browser while connected to the same home Wi-Fi.